Finding out command line parameters to a linux kernel module (modinfo)

Command line: 
  modinfo bonding

Output: 
  filename:       /lib/modules/2.6.32-400.36.4.el5uek/kernel/drivers/net/bonding/bonding.ko
  author:         Thomas Davis, tadavis@lbl.gov and many others
  description:    Ethernet Channel Bonding Driver, v3.6.0
  version:        3.6.0
  license:        GPL
  srcversion:     765520422A582FCDBFBC802
  depends:        ipv6
  vermagic:       2.6.32-400.36.4.el5uek SMP mod_unload modversions
  parm:           max_bonds:Max number of bonded devices (int)
  parm:           tx_queues:Max number of transmit queues (default = 16) (int)
  parm:           num_grat_arp:Number of gratuitous ARP packets to send on failover event (int)
  parm:           num_unsol_na:Number of unsolicited IPv6 Neighbor Advertisements packets to send on failover event (int)
  parm:           miimon:Link check interval in milliseconds (int)
  parm:           updelay:Delay before considering link up, in milliseconds (int)
  parm:           downdelay:Delay before considering link down, in milliseconds (int)
  parm:           use_carrier:Use netif_carrier_ok (vs MII ioctls) in miimon; 0 for off, 1 for on (default) (int)
  parm:           mode:Mode of operation : 0 for balance-rr, 1 for active-backup, 2 for balance-xor, 3 for broadcast, 4 for 802.3ad, 5 for balance-tlb, 6 for balance-alb (charp)
  parm:           primary:Primary network device to use (charp)
  parm:           primary_reselect:Reselect primary slave once it comes up; 0 for always (default), 1 for only if speed of primary is better, 2 for only on active slave failure (charp)
  parm:           lacp_rate:LACPDU tx rate to request from 802.3ad partner (slow/fast) (charp)
  parm:           ad_select:803.ad aggregation selection logic: stable (0, default), bandwidth (1), count (2) (charp)
  parm:           xmit_hash_policy:XOR hashing method: 0 for layer 2 (default), 1 for layer 3+4 (charp)
  parm:           arp_interval:arp interval in milliseconds (int)
  parm:           arp_ip_target:arp targets in n.n.n.n form (array of charp)
  parm:           arp_validate:validate src/dst of ARP probes: none (default), active, backup or all (charp)
  parm:           fail_over_mac:For active-backup, do not set all slaves to the same MAC.  none (default), active or follow (charp)
  parm:           all_slaves_active:Keep all frames received on an interfaceby setting active flag for all slaves.  0 for never (default), 1 for always. (int)
  parm:           resend_igmp:Number of IGMP membership reports to send on link failure (int)